Rotor Flowmeter Features
Rotameters are the most commonly used flowmeters in industry and in the laboratory. It has a simple structure, intuitive, small pressure loss, easy maintenance and so on. The rotameter is suitable for measuring small flow through the pipe diameter D<150mm, and can also measure the flow of corrosive media. When used, the flow meter must be installed on a pipe section that runs vertically and the fluid medium flows through the rotameter from bottom to top.
Rotor flow meter working principle
The rotameter is composed of two parts. One part of the rotameter is a conical tube that gradually enlarges from bottom to top. The other part of the rotameter is a rotor that is placed in a conical tube and can move freely along the centerline of the tube. . Rotameter When measuring the flow of a fluid, the fluid to be measured flows from the lower end of the conical tube. The flow of fluid impinges on the rotor and generates a force on it (this force varies with the flow rate); when the flow is large enough The resulting force lifts the rotor and raises it. At the same time, the measured fluid flows through the annular section between the rotor and the conical tube wall and flows out from the upper end. The force acting on the rotor when the fluid to be measured flows is exactly equal to the weight of the rotor in the fluid (referred to as the display weight), and the rotor is in equilibrium and stays at a certain height. Analysis shows that the height of the rotor in the conical tube has a corresponding relationship with the flow rate. Therefore, by observing the position of the rotor in the conical tube, the corresponding flow rate can be obtained.
In order to make the rotor do not touch the pipe wall when moving down the center line of the conical pipe, two methods are usually adopted. One is to install a guide mandrel in the center of the rotor to keep the rotor in the center line of the conical pipe. Up and down movement, the other is to open a track chute on the edge of the rotor disk. When the fluid flows through the rotor from bottom to top, one side bypasses the rotor and passes through the chute to generate a reverse thrust, so that the rotor does not go around the centerline. Stopping the ground can keep the rotor from hitting the wall when it is working. Rotor flowmeter rotor material can be made of stainless steel, aluminum, bronze, etc.
1. The substrate of color roof sheet can be divided into cold rolled steel sheet, hot-dip galvanized steel sheet and electro galvanized steel sheet.
2. The coating types of color roofing sheet can be divided into polyester, silicon modified polyester, vinylidene fluoride and plastic sol.
3. The color of color roof tile can be divided into many kinds according to the requirements of users, such as orange, milk yellow, dark sky blue, sea blue, scarlet, brick red, ivory, porcelain blue, etc.
4. The surface state of color corrugated steel sheet can be divided into coating plate, embossing plate and printing plate.
5. The market use of color profile roof sheet is mainly divided into three parts: construction, household appliances and transportation. Among them, the construction sector accounts for the largest proportion, followed by household appliances, and transportation only accounts for a small part.
The color Roofing Sheet for building is generally based on hot-dip Galvanized Steel Sheet and hot-dip aluminized zinc steel sheet. It is mainly processed into corrugated plate or polyurethane composite sandwich plate, which is used to build roofs, walls and doors of industrial and commercial buildings such as steel structure workshop, airport, warehouse and freezer.
Profile Roof Sheet,Color Roof Sheet,Corrugated Metal Sheet,Pre Painted Roofing Sheet,Zinc Roof Tiles
Jinan Hengming Steel Co., Ltd , https://www.jnhengmingsteel.com