Specification for use of lighting vehicle headlights

The lighting vehicle used as a light source is a metal halide. The advantage of using a metal halide as a light source is that it emits light through the action of an internal light-emitting tube and air, so that the filament of the conventional lighting method does not break and the service life is short. Metal halides not only have a long service life, but their brightness is 6 times that of tungsten lamps compared to tungsten lamps of the same power, and their power consumption is only one-fifth that of tungsten lamps.

A complete lighting car consists of a body, a pole, several or one headlight. The entire vehicle is equipped with 2 to 4 wheels, an anti-roll bracket and a generator for power supply. The body poles are lowered by means of winches or hydraulics to lower the height. The luminaires are placed on the poles. Each luminaire can be rotated horizontally up and down to allow illumination in multiple directions.

As an important part of the engineering lighting vehicle, the use of lighting lamps is an important prerequisite for safe production and safe lighting. Therefore, when using the light, it must be strictly installed to use the specification to operate.

Lamps must be used at rated voltage and frequency. Always check the condition of the grounding line for grounded fixtures. It is important to avoid the use of ordinary luminaires above or near heaters such as electrical, liquefied petroleum gas, kerosene stoves, or places that can directly contact steam. It is also not possible to carry out repairs to the lights in areas where there is a danger such as liquefied gas or steam.

Lamps that can only be used indoors are not allowed to move outside and lamps cannot use lamps that exceed the rated wattage. When changing the lamp and disassembling the lamp cover, you must cut off the power before proceeding. Check the lights regularly to ensure that no abnormalities occur during use. Do not place flammable items such as paper cloth around the light or directly cover the light. When scrubbing the lamp, use warm water for scrubbing. Do not use volatile gases such as gasoline or diesel.

The metal part of the luminaire should not be lightly polished, and the dust behind the luminaire should be cleaned with a dry cloth or tweezers. When an abnormal situation occurs in the process of using the lamp, it should be stopped, cut off the power supply, and inspected. The above is a brief introduction to the use of lighting vehicle headlights. (Wen/Jun Xun)

Hand-Push Light Tower

Light Tower Generator,Hand-Push Light Tower,Flood Light Tower,Available Light Tower

Shandong Storike Engineering Machinery Co., Ltd. , https://www.storikemachinery.com

Posted on