Scissor Lift Safety Procedures

Scissor Lift Safety Procedures

Please focus on the following points when scissor lift working:

1.The operation person of scissor-type aerial work platform must take part in the training of fall protection and counterbalanced before start the operation of equipment.

2.The main body of scissor-type aerial work platform should be labeled with the following contents: Lift speed limit, rated load capacity, maximum lifting height, manufacturer's name and production date, etc.

3.The scissor-type aerial work platform can be used after on-Site safety engineer acceptance and hang permission to use the card .

4The operation person must check the lifts before using them daily and fill out the checklist.

5.The users of the scissor-type aerial work platform shall be operated in accordance with the counterbalanced operating procedures.

6.The working area of the scissor-type aerial work platform must be on the empty flat ground and not allowed to operate on the uneven surface of the potholes.

7.The platform leg must be fully opened and supported by a firm

8.When the platform is in the ascendant position, the operator cannot leave

9.The use of scissor-type aerial platforms must be worn with a full body seat belt

10.The platform operation area must use the warning belt to maintain, sets up the warning sign, and sets up the full-time Guardian personnel

High-altitude platform in high-altitude work to bring convenience to us at the same time, we have to face is a number of security risks, such as in the construction site scissor Lifting platform should focus on preventing its overturning, scraping, electric shock and so on several aspects. such as in the construction of electricity, need to be responsible for the management of electricity, according to the engineering department's notice, from the designated power point to the construction of the

distribution cabinet, in addition, not allowed to randomly connected.

All power tools using leakage protector, electric equipment with 0 protection, and repeat grounding. In the daily use of the process should also focus on doing a good job before the full use of the inspection, use of the monitoring, after the use of maintenance.