Faults outside the car, easy to learn repair tips

It is inevitable that there will be some breakdowns when driving out. If there is a fault or fault in the driving and there is no need for emergency spare parts supply temporarily, we have to take some emergency repair methods. Now we will introduce some simple and easy emergency repair methods to everyone.

1. Damage to the fuel tank: When the vehicle is in use, it is found that the fuel tank leaks oil. You can wipe the oil spill clean. Apply soap or bubble gum to the oil leak and temporarily block it. Use epoxy resin adhesive for repair.

2. Bursting the tubing: When the tubing ruptures, wipe the cracked area clean, apply soap, wrap it with a piece of cloth or tape around the broken tubing, bind it tightly, and apply a layer of soap.

3. The tubing is broken: When the tubing is broken, you can find a rubber or plastic tube fitting that matches the diameter of the tubing. If the socket is not tight enough, tie the two ends together to prevent oil leakage.

4. Blisters appear in the cylinder head and oil leakage, leakage: According to the size of the trachoma, use the electric fuse with the corresponding specifications, and gently poke it into the trachoma with a hand hammer, then you can eliminate oil leakage and water leakage.

5. Oil leakage in the oil pipe joint: When the motor vehicle is used, if the engine oil pipe joint leaks, the tubing flare and the oil pipe nut are mostly not sealed. The cotton yarn can be used to wrap around the lower edge of the horn and tighten the tubing nut and tubing connector. The bubble gum or maltose can also be chewed into a paste, coated on the tubing nut seat and allowed to dry to seal.

6. Inflow and outflow hose rupture: When the rupture is not large, use a cloth coated with a layer of soap to wrap the leak; if the rupture is large, you can cut off the hose and put a bamboo tube or iron in the middle. Tube, and tied tightly.

7. The fan belt breaks: The broken belt can be tied up or the car can be driven off using the method of opening and stopping.

8. Screw hole slider: The screw hole slider can cause oil leakage or loose linkage, making it unable to work. At this time, the original screw can be flattened with a hammer, so that the expansion of both sides of the expansion and then tightened, but not dismantled many times, to be repaired when the next maintenance.

9. Diaphragm or oil pump diaphragm rupture or break: The oil pump can be disassembled to take out the diaphragm, and then sawn with a plastic board, an electrician insulating bakelite or a plastic cloth according to the original shape and size, and polish it.

10. The valve spring breaks: After the valve spring is broken, the broken spring can be removed, and the broken two sections can be installed in reverse and can be used. You can also find a piece of 1 mm thick sheet metal, cut into 1 mm larger than the spring diameter of the disk, cut a round hole inside, the diameter is less than the spring diameter of 4 mm, the outer edge of every 6 mm into a 4 mm long slit, cut After every good one piece is folded one by one to form a double-sided spring seat groove, and then the spring turn head can be used in the tin groove.