![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
First, inside and outside maintenance 1. Finish the sawing machine and auxiliary tools 15 minutes before work, wipe the machine tool, remove iron filings, dust, oil, and relax the saw.
2. Inspect the screws on each part to see if the nut, handle, and handle ball are loose or damaged. Keep the sawing machine in good condition.
3. Regularly disassemble the relevant cover to wipe the internal parts, so that the inside and outside of the sawing machine are clean, intact and prevent rusting.
Second, hydraulic, transmission system 1. Wipe the rails and sliding surfaces 15 minutes before work.
2. Periodically clean the worm gear box, adjust the gap between the transmission parts, and fasten the bolts and nuts of each part.
3. Lubrication System 1. Before starting the band sawing machine, lubricate the various parts of the sawing machine according to the lubrication instructions.
2. Regularly check whether the concentration of lubricant and the amount of emulsified chip fluid in the worm gear box and in the tank are in place.
3. Regularly clean all parts of the lubrication mechanism to keep the oil line free from leaks.
4. Check whether electrical equipment, motors, cables, switches, and lighting are intact and safely grounded before driving.
2. Inspect the screws on each part to see if the nut, handle, and handle ball are loose or damaged. Keep the sawing machine in good condition.
3. Regularly disassemble the relevant cover to wipe the internal parts, so that the inside and outside of the sawing machine are clean, intact and prevent rusting.
Second, hydraulic, transmission system 1. Wipe the rails and sliding surfaces 15 minutes before work.
2. Periodically clean the worm gear box, adjust the gap between the transmission parts, and fasten the bolts and nuts of each part.
3. Lubrication System 1. Before starting the band sawing machine, lubricate the various parts of the sawing machine according to the lubrication instructions.
2. Regularly check whether the concentration of lubricant and the amount of emulsified chip fluid in the worm gear box and in the tank are in place.
3. Regularly clean all parts of the lubrication mechanism to keep the oil line free from leaks.
4. Check whether electrical equipment, motors, cables, switches, and lighting are intact and safely grounded before driving.
The Knock Sensor is located on the engine block, cylinder head or intake manifold. This is because its function is to sense vibrations caused by engine knock or detonation. The PCM uses this signal to alter the ignition timing and prevent detonation. It will compare this information with its preset tables to identify a valid knock or ping. If a ping is sensed, it will retard the ignition timing to protect the engine from this damaging pre-ignition.
Knock Sensor
Knock Sensor,Auto Knock Sensor,High Performance Knock Sensor,Gm Car Knock Sensor
NINGBO DGOFEN AUTO TRADE CO., LTD , http://www.dgofen.com