![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
1. The operator must be familiar with the performance and structure of the machine tool and prohibit the use of super performance.
2. Before the vehicle is driven, oil should be filled according to the lubrication regulations to check the oil quantity, oil quality, and whether the oil path is unimpeded. Check for looseness of the fastening Screws and the Anchor bolts everywhere.
3. The gap between the blades should be determined according to the thickness of the sheared steel plate and must not be greater than 1/30 of the thickness of the steel plate.
4. The blades must keep the edge sharp, and the upper and lower flank must be kept parallel. When cutting the sheet, the blade must be in close contact.
5. Before turning on the machine, the upper blade and the lower blade should be aligned and the skew device should be adjusted. After two or three empty operations, the work can begin.
6. The shears shall not cut the bar Stock, and no other articles shall be placed on the workbench so as not to enter the cutting edge and damage the machine tool.
7. When cutting sheets of different thicknesses and different materials, the pressure of the pressure plate spring and the clearance of the blade should be adjusted properly to prevent the spring from breaking or damaging the cutting edge.
8, always pay attention to the clamping mechanism and clutch, brake failure phenomenon; to concentrate when cutting, always pay attention to the operation of the machine, if the failure or abnormal phenomenon should be shut down for maintenance.
9. When the operator leaves the site or adjusts, inspects, or cleans, it should stop.
10. At the end of the work, the machine tool should be wiped as required to clean the site, keep it clean, and cut off the power and air supply. If it is not used for a long period of time, the blade should be wiped clean, coated with new oil, and affixed with clean paper to prevent rust.
2. Before the vehicle is driven, oil should be filled according to the lubrication regulations to check the oil quantity, oil quality, and whether the oil path is unimpeded. Check for looseness of the fastening Screws and the Anchor bolts everywhere.
3. The gap between the blades should be determined according to the thickness of the sheared steel plate and must not be greater than 1/30 of the thickness of the steel plate.
4. The blades must keep the edge sharp, and the upper and lower flank must be kept parallel. When cutting the sheet, the blade must be in close contact.
5. Before turning on the machine, the upper blade and the lower blade should be aligned and the skew device should be adjusted. After two or three empty operations, the work can begin.
6. The shears shall not cut the bar Stock, and no other articles shall be placed on the workbench so as not to enter the cutting edge and damage the machine tool.
7. When cutting sheets of different thicknesses and different materials, the pressure of the pressure plate spring and the clearance of the blade should be adjusted properly to prevent the spring from breaking or damaging the cutting edge.
8, always pay attention to the clamping mechanism and clutch, brake failure phenomenon; to concentrate when cutting, always pay attention to the operation of the machine, if the failure or abnormal phenomenon should be shut down for maintenance.
9. When the operator leaves the site or adjusts, inspects, or cleans, it should stop.
10. At the end of the work, the machine tool should be wiped as required to clean the site, keep it clean, and cut off the power and air supply. If it is not used for a long period of time, the blade should be wiped clean, coated with new oil, and affixed with clean paper to prevent rust.
DIN 912 Hex Socket Cap Screw,DIN7984 Hex Thin Head Cap Screw,Knurling Head Bolt
Bolts,Nuts,Self Drilling Screw Co., Ltd. , http://www.nssteelfastener.com